You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Welcome to SDF's staff support center!
Home > Technology > Hardware > Connecting to the Orbic Mobile Hotspot/ MIFI
Connecting to the Orbic Mobile Hotspot/ MIFI
print icon

To look up the WIFI password on the MIFI, proceed with the following steps:

 

  1. The name of the WIFI network  is on a sticker on the back of the unit. It will be “Mobile Hotspot x” ex: Mobile Hotspot 1
  2. To power device on, press and hold the green button on the left side of the device for about 6 seconds to power it up. Let go once you see the welcome screen. It will take a couple of minutes to boot
  3. From the main menu, press the WIFI icon in the lower left corner as shown below

  1. Select “WIFI Name/Password” This brings you to the password page as shown below
    1. Enter the password as shown on the device below

  1. Now that you have the device password, on your computer, connect to the WIFI device. Again, the name is on the back of the hotspot. It will be “Mobile Hotspot x” ex: Mobile Hotspot 1
  2. Find the WIFI name (Mobile Hotspot X”) on your computer by clicking on the WIFI icon on the bottom right-right corner of your Taskbar. Chose it then enter the password.
  3.  You can connect up to 10 devices on one hotspot
  4. Done!
Feedback
0 out of 0 found this helpful

scroll to top icon